Crown PowerTech Power-Tech 2 Power Amplifier PT-2 in Frederick, Maryland For Sale

Crown PowerTech Power-Tech 2 Amplifier
best offers will be considered
contact info: mgdxxxx@hushmail.com or call or text xxxxxxxx11
The amp was taken out of box for install, but I travel a lot for my job so I never got the surround sound system installed and running. It has been stored in a upstairs bedroom for over ten years. Description and pictures are from crown?s website.
Model Number:
Power-Tech 2
Electrical Requirements:
120 Volts AC, 60 Hz, 11.5 Amps
Condition:
New with out original manufacturers box, but manual included
Features:
? Rugged, professional power amplifier built for the road. Mounts in EIA standard 19-inch (48.3-cm) rack.
? Quick-access front panel power switch and level controls. Turn-on delay for loudspeaker protection.
? The patented ODEP ® circuitry and Grounded Bridge? design combine to provide performance and reliability that surpass all traditional designs.
? Easy to read signal presence (SPI) and distortion (IOC ®) indicator for each channel.
? High damping factor provides superior control over low-frequency drivers for a clean, accurate low end.
? Safe with any load. Bridge-Mono and Parallel-Mono modes make it easy to optimize the amplifier?s performance for a wide range of loads.
? Complete protection against shorted outputs, mismatched loads, overheating, input/output DC and high frequency overload; full internal fault protection.
? Balanced phone jack inputs with internal three position sensitivity switch and front-panel level controls. XLR and barrier block input connectors are optional.
? Efficient heat sinks and self-contained forced-air cooling system dissipate heat quickly and evenly for extra amplifier protection and greater output power